38
10.5
Function at the Operator Level
Working with the device
10.5.1
Actual Value to Reference
Keys 1x press at the same time
With this shortcut, the actual value (display value) on the adjustable reference value is set (in absolute mode only
possible when the offset is not enabled).
The reference value can be entered with the parameter
P09
.
10.5.2
Direct entry to value to reference
(Function is possible at firmware 1.30)
Keys 1x press at the same time
With this key combination, the value to reference P09 can be entered without switching into the parameter level.
(see on chapter 10.3)
After pressing the keys for approximately 3 seconds, the display shows the text ‘’P09’’.
If the keys are released the value to reference P09 appears, and this value can also be changed in the
parameter level.
Key 1x press to safe the value to reference
10.5.3
Switching incremental or absolute
1x pressed
With this key the indicator is switched from absolute mode to incremental mode:
The display value is temporarily set to ZERO, the symbol „INC“ appears in the display.
Actuating the key again the absolute is activated and the symbol “ABS” is displayed.
10.5.4
Activation Offset Measurements
1x pressed
This key enables/disables each of the three adjustable offset dimensions (only possible in the absolute mode). In
each case an offset is added to the display value.
The activation of an offset level is indicated by the symbols
1
,
2
or
3
.
The offset measurements can be entered in the parameter
P10
,
P11
and
P12
.
Additionally, parameters can be determined with
P13
, whether and how many offset measurements can be
selected.
Structure and Function
