ELGi EG 11, Руководство по эксплуатации и обслуживанию, Страница: 19 / 183

MOISTURE
OUTLET
PORT
Installation
Keep the air outlet line ball valve in fully open condition before starting the compressor
Connect the moisture outlet line provided at the side of the compressor as shown in above figure to the waste water disposal line.
Check the direction of rotation of the main motor when starting for the first time by switching ON the compressor (pressing
the green Start button) and switching OFF (pressing the red mushroom Stop button) immediately. The motor must rotate in
the clockwise direction when viewed from the main motor fan cooling side. If the direction of rotation is not correct, isolate the
machine from the electrical lines and interchange any two phases. Re-start the compressor and ensure that the direction of
rotation of the main motor and the fan motor is clockwise
IMPORTANT
After connecting incoming electrical phase lines, please check
if both the LED’s of Single Phase Preventer (SPP) in the control
panel glow. This ensures correct incoming wiring sequence and
the compressor is ready for start. If it is not set right, flip the
incoming phases for correct wiring sequence
Switch “ON” the compressor after ensuring all the safety points
N N
In case of problems during the running of the compressor, check
which warning LED’s are illuminated on the control panel of the
compressor and refer to the Functional Description and Operation
sections of this manual
N N
If any abnormal noise is heard when the compressor runs, switch
it off immediately and contact the Elgi service engineer for remedy
N N
All the points listed earlier should be followed, when the
compressor is re-installed at a different location
N N
If the compressor has been stored for an extended period before
commissioning, contact the Elgi distributor.
Open
Running the compressor in the wrong direction for more than 5 seconds will cause damage to compressor parts
or even total destruction
!
WARNING
Ensure that only authorized electricians carry out the electrical work. Study the electrical circuit diagram before
starting the work
!
WARNING
CLOCK WISE
19