21
DD51-E
Direct drive electronic position indicators
Models all rights reserved in accordance with the law.
Always mention the source when reproducing our drawings.
EN
The measuring mode selected is shown on the display by
the symbols:
-
mm
: millimeters
-
INCH
: inches
-
D
: degrees
It is possible to change the key function
by setting the parameter
_ _ _ _ 0
The available options are:
-
ALL
(default): units of measure that can be selected:
mm, inch, D
-
nodEG
: units of measure that can be selected: mm,
inch
-
OFF
: the key is disabled and does not allow changing
the selected measuring mode.
To program the parameters listed above, see paragraph 8.2.
7.3 Setting the absolute reference
After having selected the absolute
measuring mode and stopped the shaft
in the starting position or in the reference position, press
the key combination to set the absolute value to the sum
of the values of the parameters
OrG
(absolute value of
reference) and
OFFS
(compensation value).
The value of compensation (offset) allows you to adjust the
value shown on the display in such a way that takes into
account, for example, wear or tool change. The system
allows you to store up to 10 values of compensation.
Select the desired compensation value among the 10
available values, then press
to confirm.
_ _ _ _ 0
+
