elero VarioTec, Руководство по эксплуатации, Страница: 7 / 8

Technical data/Cleaning/
Troubleshooting
GB-12
Programming
GB-11
Adjustment to intermediate position
The shutter/curtain/blind can only be moved into the
intermediate position from the
upper end limit position.
1. Press the DOWN button twice in quick succession.
The shutter/curtain/blind is adjusted into the stored
intermediate position.
Adjustment to ventilation position (roller shutters)
Roller shutters can only be moved into the ventilation position
from the
lower end limit position.
1. Press the UP button twice in quick succession. The shutters are
adjusted into the stored ventilation position.
Adjustment to reverse position (venetian blinds)
The venetian blind slats must be closed before the blind can be
adjusted into the reverse position.
1. Press UP button twice in quick succession.
The venetian blind is adjusted into the stored reverse position.
When the blind reaches the stored intermediate position the blind
slats are turned automatically (provided a reverse position has
been pre-programmed).
Deleting intermediate position
1. Press and hold the Pos B programming button for more than
5 seconds. The intermediate position is now deleted.
The control light will flash 3 times briefly.
Deleting ventilation/reverse position
Press and hold the Pos V programming button for more than
5 seconds. The ventilation/reverse position is now deleted.
The control light will flash 3 times briefly.
GB
Nominal voltage 230-240 V AC / 50-60 Hz
Switched current 5 A /250 V AC for cos j = 1
System of protection IP 20
Protection class II
Permissible ambient temperature 0 to +55 °C
Type of installation Concealed:
l
58 mm wall-
mounted
Exposed: in appropriate
exposed casing
Technical data
Cleaning
Clean the device with a damp cloth only. Do not use a cleansing
agent as doing so may damage the plastic.
Troubleshooting
Problem Cause Remedy
Drive is not functioning. Faulty connection. Check connection.
Drive moves in the Faulty connection. Exchange
V
and
B
wrong direction. wires in the power
supply unit.
VarioTec does not 1. Device is set to 1. Set the device to
carry out external manual mode. automatic mode.
control commands. 2. Alarm signal is active. 2. Wait until alarm
signal disappears
or rectify problem
causing signal.
General declaration of conformity:
The company elero GmbH hereby declares that the VarioTec device
complies with the basic requirements and other relevant regulations
of the EC Directive 1999/5/EG.