USA-8
US
A
USA-7
Programming radio channel settings
Programming transmitter/channel
Prerequisite:
The receiver must be installed.
1. With pre-installed electric receivers, the fuse must be disconnec-
ted and reconnected after a few seconds. The receiver will remain
in programming mode for approximately 5 minutes.
2. Position yourself in front of the roller shutter/awning/blind with
the remote control in your hand.
3. Open the front cover of the device and press the transmitter pro-
gramming button
P briefly
. The shutter/awning/blind will start to
move up and down. This will happen for approximately 2 minutes.
4. To define the keyboard layout, press the
UP
button on the
transmitter as soon as the shutter/awning/blind begins to move
upwards (after approx. 1 second). The shutter/awning/blind will
come to a halt briefly. As soon as the shutter/awning/blind begins
to move again, press the
DOWN
button on the handheld
transmitter.
The shutter/awning/blind will come to a stop.
The transmitter or this channel has been successfully programmed.
Programming additional transmitters
To programme additional transmitters in one receiver, please
proceed as follows:
1. Press the
UP, DOWN
and programming button
P
on a transmitter
that has already been programmed in the receiver until the LED
goes out.
2. To define the keyboard layout, press the
UP
button on the hand-
held transmitter as soon as the shutter/awning/blind begins to
move upwards (after approx. 1 second).
The shutter/awning/blind will come to a halt briefly.
As soon as the shutter/awning/blind begins to move again, press
the
DOWN
button on the handheld transmitter.
The shutter/awning/blind will come to a stop. The transmitter or
this channel has been successfully programmed.
Explanation of functions
Transmission control light
The transmission control light is illuminated when a radio
signal is being transmitted.
The transmission control light will flash during transmission if
battery power is low.
The transmission power or radio operating range will decrease
as battery power decreases. If the transmission control light
does not light up when the buttons are pressed, the batteries
must be replaced.
Group control
Group control refers to the operation of one or more receivers
at the same time. The group selected is controlled via a control
command.
The MonoTel-915 has one radio channel which is used for
group control.
Note:
The inlay card located below the transparent cover can
be used to make a note of the group which has been
programmed.
