elero MonoTel 2, Руководство по эксплуатации, Страница: 6 / 13

© elero GmbH EN 10 © elero GmbH EN 11
Group control unit
A group is understood to mean the control of several receivers at the
same time. The selected group is controlled by a travel command.
Any number of receivers can be programmed and controlled in the
channel.
Programming the transmitter
Requirement
The receiver is installed. Check whether the channel has been
deleted or is in the correct mode according to the status display.
Stand in front of the blind to be programmed while the programming.
1. With electrical receivers which have already been installed, switch
the circuit breaker off and on again after a few seconds.
The receiver is now in programming mode for about 5 minutes.
2. Press the programming button P on the rear of the device brie fl y
(approximately 1 second) until the status display lights up brie fl y.
The blind moves up and down for approx. two minutes, showing
that the receiver is in programming mode.
3. Press the UP button as soon as the blind starts moving in Open
direction (within 1 second at the most). The status display lights
brie
fl y.
The curtain stops brie fl y, travels further, stops and then travels in
the downwards direction.
4. Immediately (no more than 1 second) the curtain starts moving
downwards, press the DOWN button. The status display lights up
brie fl y. The blind stops. The transmitter channel is programmed.
Note
Programming will have to be repeated if the curtain does not
stop.
A bidirectional programming process in the hand-held transmitter
can be cancelled by pressing the
STOP button for 6 seconds.
Programming additional transmitters
Note
Multiple receivers connected to the same supply are all
simultaneously ready for programming for approximately
5 minutes after connection to the mains.
If the
P button is now pressed on the transmitter, all receivers
start the programming mode simultaneously (ascents/
descents). An offset is created between the receivers by
randomly different pauses between the ascentsdescents. The
longer programming is delayed, the greater the offset will be.
The brief ascents/descents can be stopped by pressing the
STOP button brie fl y on a transmitter that has already been
programmed. The programming mode in the receiver is
interrupted.
The transmitter can now be assigned without having to
disconnect individual receivers. If the blind moves in the wrong
direction, delete the transmitter and program it again.
(
→
see Deletion of transmitter)
For programming additional transmitters to one receiver:
1. Press the
UP , DOWN and programming P (rear of the device)
buttons simultaneously (for three seconds) on a transmitter
that has already been programmed to the receiver. The status
display lights up brie
fl y. The receiver is now in programming
mode.
2. Press the programming button P on the transmitter to be
programmed until the status display lights brie fl y. The receiver is
now in programming mode (ascents/descents).
3. Press the UP button immediately (within no more than 1 second)
the curtain starts moving upwards. The status display lights
brie
fl y. The blind stops brie fl y, starts moving again and then
moves downwards.
4. Immediately (no more than 1 second) the curtain starts moving
downwards, press the DOWN button. The status display
Explanation of functions Explanation of functions