GB-18
GB
GB-17
Battery changing/cleaning/disposal
Battery replacement
N O T I C E !
• Replace batteries only with identical type
(2 x LR 06; AA cells).
• Dispose of used batteries properly
(collection point).
1. Unscrew the hand-held transmitter using
a suitable screwdriver on the underside of
the device and remove the cover.
2. Remove the batteries.
3. Insert the new batteries (2 x LR 06; AA cells)
correctly
in the transmitter.
4. Place the cover on the housing again and screw
on tightly with the screwdriver.
Cleaning
Clean the device with a damp cloth.
Don’t use any cleaning agents. This may attack the plastic.
Disposal
Please observe the current national regulations. Dispose of
according to the condition and existing regulations.
e.g. as:
• Electrical scrap (PCB)
• Plastic (Housing parts)
• Batteries
Troubleshooting/repair
Notes on troubleshooting
Fault
Cause
Remedy
The drive does
1. Batteries are low.
1. Replace batteries.
not run, the status
LED does not
2. Batteries are
2. Insert batteries
light up.
incorrectly installed.
correctly.
The drive does
1. The receiver is outside
1. Reduce distance
not run, the status
the radio range.
to the receiver.
LED lights up red.
2. Receiver out of
2. Switch on or
order or faulty.
exchange receiver.
Drive operates in
Directions are
Delete transmitter
the wrong direction. incorrectly allocated.
and reprogram.
Notes on repair
Please contact us if you are unable to eliminate a problem.
When contacting our service team, please always state the item
description and number from the type plate (back of device).
– Item number
– Accompanying conditions
– Item description
– Own presumption
– Type of fault
– Previously occurring unusual
events
Repair address:
elero GmbH
Antriebstechnik
Linsenhofer Straße 59–63
D-72660 Beuren
Telephone (0 70 25) 13-01
Please visit us on the Internet
Fax (0 70 25) 13-212
if you require a contact outside
www.elero.com
Germany.
