elero LumeroTel, Руководство по эксплуатации

Страница: 5 / 8

GB-8
GB
Programming radio channel settings
GB-7
Programming transmitter/channel
Prerequisite: The receiver must be installed.
1. With pre-installed electric receivers, the fuse must be
disconnected and reconnected after a few seconds. The receiver
will remain in programming mode for approximately 5 minutes.
2. Position yourself in front of the roller shutter/awning/blind with
the remote control in your hand.
3. Open the front cover of the device and press the transmitter pro-
gramming button P briefly. The shutter/awning/blind will start to
move up and down. This will happen for approximately 2 minutes.
4. To define the keyboard layout, press the UP button on the trans-
mitter as soon as the shutter/awning/blind begins to move
upwards (after approx. 1 second). The shutter/awning/blind will
come to a halt briefly.
As soon as the shutter/awning/blind begins to move again, press
the
DOWN button on the handheld transmitter.
The shutter/awning/blind will come to a stop.
The transmitter or this channel has been successfully programmed.
Programming radio channel settings
Programming additional transmitters
To programme additional transmitters in one receiver, please proceed
as follows:
1. Press the
UP, DOWN and programming button P on a transmitter
that has already been programmed in the receiver until the LED
goes out.
2. To define the keyboard layout, press the UP button on the handheld
transmitter as soon as the shutter/awning/blind begins to move
upwards (after approx. 1 second).
The shutter/awning/blind will come to a halt briefly.
As soon as the shutter/awning/blind begins to move again, press
the
DOWN button on the handheld transmitter.
The shutter/awning/blind will come to a stop.
The transmitter or this channel has been successfully programmed.
Note: If more than one receiver is connected to the same supply
lead, all of these will be in programming mode
simultaneously. The shutters/awnings/blinds will begin to
move up and down “at random”. The longer you take to
carry out the programming, the larger the offset will be.
Individual channels can now be assigned to the given
receiver.
To stop the brief up and dpwn movements, press the
STOP button on one of the pre-programmed handheld
transmitters briefly.
Channel assignment /modification can now be carried out
without you having to disconnect individual receivers.
If the shutter/awning/blind moves in the wrong direction,
the transmitter must be deleted and re-programmed.