Elenco Electronics XK-700-SEMI, Сборка и инструкция по эксплуатации

Страница: 11 / 40

-10-
MOUNT COMPONENTS TO PANEL
Push the illuminated switch into the hole in the top panel with the lugs as shown in Figure J.
Install the fuse holder with the side lug in the position shown in Figure J. Fasten the fuse holder in place with
the nut as shown in Figure K. Unscrew the cap and insert the fuse into the holder.
Back Side - Lower
Right Corner
Figure J
There is a raised area on the back side of the top panel. Screw the spacer to the raised area by inserting a
4-40 x 1/4” flat head screw into the hole in the raised area from the top side of the panel (see Figure L).
Put the two bredboards together as shown in Figure Ka.
When mounting the bredboard, use the holes shown in Figure Kb. Mount the plastic spacer with a 4-40 x
1/4” flat head screw as shown in Figure L. Next, mount the bredboards with two #4 x 1/4” AB black screws
from the back side of the top panel as shown in Figure L. The negative (blue) stripe should be on top and
the numbers reading from left to right should start with number 1 (see Figure M). CAUTION: Do not remove
the paper backing from the back of the bredboards. Do not over-tighten the black screws.
9426
9830
9830
9426
Use these
holes
Use these
holes
Figure Ka
Figure Kb
Side
Lug
Fuse Holder
Illuminated Switch
Nut
Top Panel
Plastic Washer
Fuse Holder
Figure K