Elenco Electronics M-1150K, Сборка и инструкция по эксплуатации

Страница: 5 / 16

-4-
Figure F
Battery snap - Insert red or white wire
through the hole marked B2+ and black or
blue wire through hole marked B2--. Then
solder wires to PC board.
Figure E
Insert fuse clips through the
PC board. Be sure tabs are
positioned as shown below.
Solder clips to PC board. Be
sure to heat clips thoroughly
when soldering. Install the
0.5A fuse.
Tabs
r R14 - 360K
Ω
1% 1/4W Resistor
(orange-blue-black-orange-brown)
r R15 - 1.8M
Ω
1% 1/2W Resistor
(brown-gray-black-yellow-brown)
r R16 - 6.75M
Ω
1% 1/2W Resistor
(blue-violet-green-yellow-brown)
r D1 - 2CZ82P Diode
(see Figure C)
r Wire - 2” Long
r R8 - 15M
Ω
1% 1W Resistor
(brown-green-black-green-brown)
r R7 - 4M
Ω
1% 1/2W Resistor
(yellow-black-black-yellow-brown)
r R6 - 800K
Ω
1% 1/4W Resistor
(gray-black-black-orange-brown)
r R5 - 150K
Ω
1% 1/4W Resistor
(brown-green-black-orange-brown)
r R3 - 5K Ω 1% 1/4W Resistor
(green-black-black-brown-brown)
r R4 - 40K
Ω
1% 1/4W Resistor
(yellow-black-black-red-brown)
r Wire - 1 3/4” long
r Wire - 3” long
r R10 - 102
Ω
1% 1/4W Resistor
(brown-black-red-black-brown)
r Fuse Clips / Fuse 0.5A
(see Figure E)
r R9 - 3K
Ω
1% 1/4W Resistor
(orange-black-black-brown-brown)
r R13 - 83.3K
Ω
1% 1/4W Resistor
(gray-orange-orange-red-brown)
r Battery Snap
(see Figure F)
r R25 - 10K
Ω
Pot
(see Figure D)
Note: Make sure that the lead from
D1 doesn’t short to R2, B2+ or R13.
Figure D
Mount the 10K
Ω
pot to the foil side of the PC board as
shown. Solder the leads to the foil side of the PC board.
10k
Ω
Pot
Foil Side of PC Board
Red or White
Black or Blue