Elenco Electronics AK-710, Сборка и инструкция по эксплуатации

Страница: 8 / 12

-7-
Mount the slide switch onto the foil side
of the PC board. The tabs on the switch
must go through the slots of the PC
board.
Solder the switch to the PC
board.
Strip the insulation off of both ends on
the remaining 2 1/2” of black wire and the
7” of red wire to expose 1/8” of bare wire.
Mount and solder the black wire to the
foil side of the PC board in hole J4 (–)
and the red wire in hole J3 (+).
Solder the free end of the black wire to
the negative (–) clip.
J3
J4
Foil Side of PC Board
Insert the free end of the red wire
through the slot in the bottom case
and solder to the positive (+) clip
(see Figure D).
Pull the wire back through the slot and
insert the clip into the case and bend
the tab as shown in Figure E.
(+) (–)
Foil Side
Figure D
Red Wire
Figure E
Pull wire down
Bend tab