Elenberg WM-3620D, Инструкция по эксплуатации

Страница: 15 / 20

15
Removing the shipping bolts
Before using the washing machine, you must remove all of the ship-
ping bolts:
1. Take the top cover down.
2. Loosen and take the two bolts down from the fasten stand, the
polyfoam interleaf under the stand also be taken out.
3. Instal the cover as before.
4. Keep the shipping bolts and spring block for future shipment
use.
Adjusting the leveling feet
If the loor is uneven, losen the leg bolt by turning it with your hand
until it is at the desired height. Then tighten the locking nut by
turning it with the wrench.
Connecting the water supply hose
1. Take the cold water supply hose and connect to the cold water
supply intake on the back of the machine. Tighten by hand.
2. Connect the other end of the cold water supply hose to water
faucet and tighten it. The proper faucet should be chosen and
its mouth is lat.
3. Make sure the connection is good without leaking. No excessive
bending for the water tub by hands.
Connecting the water drain hose
The drain hose should not be placed 80-100cm high above the
loor. The strap and retainer should be applied to protect the loor
from damage due to water leakage.
UNPACKING AND INSTALLATION