Elenberg WM-3610M, Инструкция по эксплуатации, Страница: 20 / 21

20
1. The machine won’t start.
• Check the door is closed properly
• Check that the machine is plugged in and that the electricity is on.
• Check that the programme dial is in the correct position and that
the ON/OFF button is pressed down.
2. The machine won’t fill.
• Check that the tap is turned on.
• Check that there are no kinks in the water intake hose.
• Check that the filter is not blocked.
• Check the door is closed properly.
• Check that the programme dial is in the correct position.
• Check that the water pressure is strong enough (minimum 0.5
bar).
3. The machine fills and empties immediately.
• Check that the runoff hose is not positioned too low.
• Check that the runoff hose is mounted properly.
4. The machine does not empty and/or the drum does not turn.
• Check that there are no kinks or snags in the water intake
hose.
• Check that the runoff hose is installed properly and there re no
blockages.
• Check whether the button for anti-crease is set (the water remains
in the drum after the last rinse for this kind of programme).
5. There is water on the floor.
• Check that there are no kinks or snags in the water intake
hose.
• Check that the runoff hose is not punctured.
• Too much detergent means too much foam: this will run over.
6. The laundry is not washed properly.
• The quantity of detergent was not sufficient or was not up to
standard.
• The temperature setting was not correct for this wash.
• Stubborn stains should be pretreated before each washing.
7. The machine is vibrating a lot or is making a lot of noise.
• Check that the transit screws have been removed.
• Check that the adjustable feet of the machine are all firmly on
the ground and that the counter nut on each one has been tight-
ened properly.
• Check that the washing is well distributed in the drum.
• There is not enough washing in the machine.
TROUBLESHOOTING