Elenberg WM-3070T, Инструкция по эксплуатации

Страница: 13 / 18

13
installation of the bottom plate
1. Laydownthemachineonitsfrontside.
2. Place the panel against the bottom of the ma
-
chine.Aligntheholesinthepanelwiththeholes
inthewasher.
3. insert the screws through the holes of the panel
intothebottomofthewasherandtighten.
adjustment
Thedistancebetweenthewasherandthewallmustbemorethan2
cm;thealloweddecliningangleofthesupport’sbaseissmallerthan2
degree.
The inclination or uneven of the
ground will cause running un-
steadilyorstoprunning,pleasead
-
justitfollowingthemethodbelow.
Loosentheadjustablenut.Thelev
-
elinglegcanbeadjustedbyturn
-
ingitcounter-clockwisetoraisethewasherandclockwisetolowerthe
washer.
Connecting the inlet hose to water supply
Connecttheoneendoftheinlethosetowatersupplyandtightenit.
Theproperfaucetshouldbechosenanditsmouthislat.
makesuretheconnectionisgoodwithoutleaking.Noexcessivebend
-
ingforthewatertubbyhands.
install the inlet hose
1. Attachtheinlethose’sfaucetconnectortothefaucet.
2. do not take the waterproof gasket
down, check whether it falls off or
has been damaged before using
eachtime.
3. Place the hose nut on the inlet
valve
4. Screwdownthehosenut,androckitslightlytoinsurethatthecon
-
nectionisreliable.
Attention:
The temperature of incoming water mustn’t be above 50° C.
install the drain hose
1. The height of the drain hose ‘s
outlet end must be between 29’
and40’fromtheground.
2. Usethedrainpipehookincluded
in the accessories to sustain the
drain pipe, and keep the outlet
endinixedpositiontopreventtheoverlowingofwater.Toprevent
thehookcomingoff,fastenitusingwaterproofrope.