Elenberg RF-0925, Инструкция по эксплуатации

Страница: 14 / 18

14
from the left side, please follow the instructions below.
NOTE:
All the removed parts must be well kept for the reinstallation of the
door.
FigURe 1 (Normal position) FigURe 2 (Position after door reversal)
1. Upper hinge cover
2. Screw
3. Upper hinge
4. Door
5. Lower Door hinge
6. Screw
7. hole cover
8. Cabinet
9. Pin cap
• Remove the three screws (6) that hold the lower door hinge (5), keep the
hinge for later use.
• Remove the door from the upper pin (3), and keep the padded surface up
-
wards to prevent the scratching.
• Remove the upper hinge cover (1), remove the two screw (2), hold the upper
hinge (3), save the hinge for later use.
• Remove the hole cover (1) and transfer it to the same location on the oppo
-
site side.
• insert the lower door hinge in the right side, ix the lower right hinge by
tightening all the screws.
• Remove the pin cap (9) from the right side of the upper frame of the door,
and then transfer it to the same location on the opposite side.
• Put the door on the Lower Door hinge (5), keep the door level , and then ix
the upper hinge (3) to the body (4) by the screws
• Put on the upper hinge cover (1).