Elen NDA 100/3-2 TH RG L30 230AC PoE LAN, Руководство пользователя

Страница: 12 / 13

12 User Manual / NDA 100/3 TH(S) RG L30 230AC (PoE) LAN
Display settings
Display mode
Sensor No. 1
Sensor No. 2
Average from 2 sensors
Sensor No. 1 / Sensor No. 2 / Average from 2 sensors
Display will show measured value from sensor No. 1 as
configured above.
Display will show measured value from sensor No. 2 as
configured above.
Display will show average value from 2 sensors.
Address for RS485 bus 1
– 255
Designates internal RS485 address ID number of display.
Brightness mode
Automatic
Direct
Automatic / Direct
Automatic control of brightness according to ambient light
conditions, via built-in light sensor.
Direct control of brightness via fixed brightness level
entered by user.
Default factory setup is automatic.
Brightness level /
curve slope 1
– 100
If Direct mode is selected above, this value sets fixed LED
brightness level from 1 to 100.
If
Automatic mode is selected above, this value sets the
slope of brightness regulation curve.
Default factory value is
90 .
MAC address
Shows MAC address of connected display.
User cannot change this field.
IP address Shows IP address of display (same IP address as in the
URL field of the browser). Factory default IP address is on
the label located on the back panel of display.
Enter new IP address according to your LAN setting.
Subnet mask Shows factory default Subnet mask of connected display.
Enter new Subnet mask according to your LAN.
Gateway address
Shows factory default Gateway address of connected
display.
Enter new Gateway address according to your LAN.
TCP/IP port Shows factory default TCP/IP port: 10001
Note: Do not forget to press the Set button after making each change.
Otherwise the change will be discarded. When finished with settings, click the
Refresh button.