User Manual
– Monitoring Swimming Pool Water Temperature
3
Once in the function menu, use the
Upp arrow
/
Down arrow
to select item to
change and confirm your selection with
OK
button (located in the middle of arrows).
F1
OFS
Correction offset. Using the up/down arrow set the value of desired
offset correction for the measured values. Default factory setting is
0,0°C. (Not normally used as the sensor is already calibrated.)
tU
Temperature units. Select °C or °F. (Can require label change as
well.)
F2
CoL
LED color setting. (
Feature used in color LED displays only.
)
Select desired color by holding button
„up arrow“ / „down arrow“
,
to change color and confirm with
OK
button.
F3
Lou
Sets the lower limit. When this limit is exceeded:
Value on display will be blinking when blinking function is ON.
UPP
Sets the upper limit. When this limit is exceeded:
Value on display will be blinking when blinking function is ON.
bOL
Blinking (flashing) of display ON / OFF. Sets the blinking of display
after exceeding the upper or lower limit. Select
oFF
or
on
.
F4
CHA
Sets the channel number of RF transmission with the floating sensor.
Floating sensor has ability to transmit on 3 different channels 1, 2, 3.
The CHA setting in display must match with the channel setting in
the sensor. Channel number in the sensor can be changed with the
switch inside the sensor. Factory default setting is “1”. To change the
channel number use the
„up arrow“ / „down arrow“
keys.
Different channel numbers can be used in case there are more swim-
ming pools with floating sensors. Each display can be paired with one
corresponding floating sensor using its transmitting channel number.
Mod
This feature allows two different Modes of display operation.
Aut
–
automatic, display receives the measured temperature data
from floating sensor.
MAn
–
manual, temperature value is entered manually via IR remote
control with the
„up arrow“ / „down arrow“
keys. This feature can
be used without floating sensor, in case the user measures the water
temperature by other means (e.g. analogue thermometer) and enters
the value manually. Please note in Manual mode the displayed value
after power off / on will be set to preset value of 27°C.
