Access to the complete installation manual and product warranty at www.plycem.com
BRIEF INSTALLATION GUIDE
EUREKA TANK
◾
Make sure the level of the support surface of the tank.
◾
Make sure that the support surface is larger than the bottom of the tank.
◾
Do not place the tank on irregular fl oor.
◾
Do not place the tank on separate parts or beams.
◾
Do not install the tank underground.
◾
Do not place the tank on irregular surfaces, vegetation, elements that may damage the bottom of the tank.
The tank should be cleaned every 6 months, so consider the following points.
◾
Shut off the water supply to the Eureka tank.
◾
Empty your Eureka tank to about 5 cm of water at the bottom.
◾
Shut off the water supply to your house by closing the valve.
◾
Wash the inside walls and bottom of your Eureka tank with a plastic brush and liquid disinfectant soap.
◾
Remove the multi-connector discharge plug, remove all contents and rinse.
◾
Make a fi nal cleaning of the inside walls and bottom with a clean, dry rag or mop.
◾
Install the discharge plug on the multiconnector and open the valve that supplies water to your home.
◾
Turn on the water supply to your Eureka tank, wait for it to fi ll and it is ready to use.
◾
Tanks should be washed before installation.
◾
The tank should be always cleaned every six months. Check the fi lter and connections and make the necessary
adjustments and repairs.
◾
The tank should be always covered.
◾
When using a pumping system, the pipe should be anchored at the tank inlet to absorb any movement over the tank
connector.
◾
The system should be installed in an easily accessible location to allow for inspection and to facilitate proper
maintenance.
◾
When storing the tank prior to installation, be sure to keep it in an upright position on a smooth, level surface.
◾
The temperature of the liquid to be stored must not exceed 60° Celsius.
◾
For the installation of additional accessories to the tank, it is important to consult with your distributor warehouse.
It is important that you consult your authorized supplier beforehand.
Step 3:
Your tank (1) has a threaded fl ange (2). Screw on the multi-connector (3) with 1/2”
or 3/4” exit. Use the one that corresponds to the diameter of your distribution pipe (5). Use
only your hands to tighten it. Turn until the threaded plug of the air jug (4) is facing upwards
and the cleaning plug (6) is on one side as shown in the fi gure. Remove the plug and insert
the air jug tube (4). Connect the multiconnector (3) to the distribution pipe (5) as shown.
1
2
3
4
5
6
Male adapters 1/2”
Float
Filter
Multi connector
valve
Tee PVC 1/2”
PVC elbow 1/2”
Shut-off
valve
Water inlet and
outlet
Outlet pipe
support
Connecting
flange
PVC elbow 1/2”
Check
valve
Air jug
INSTALLATION
PRECAUTION
MAINTENANCE
