8
1. Connect a HDMI
TM
or DVI source (e.g., a Blu-ray Disc player) to the transmitting unit.
2. Connect a HDMI
TM
or DVI display (e.g., a HDTV) to the receiving unit.
3. Connect two solid Cat-5/5e/6 UTP/STP cable between the transmitting and receiving
units.
4. Make sure these two solid Cat-5/5e/6 UTP/STP cable are tightly connected and not
loose.
5. If you want to control the source devices at display side, plug in the IR blaster to the
transmitting unit and the IR receiver to the receiving unit. If you want to control the
display at source side, plug in the IR receiver to the transmitting unit and the IR blaster
to the receiving unit.
6. Plug in the 5V DC power supply unit to the latch-locking power jack on either the
transmitting unit or the receiving unit.
7. If you see flickering or blinking image on the display, adjust the rotary control switch
to improve the cable skew. 0 stands for the strongest HDMI
TM
signal level for longest
possible transmission length while 7 stands for the weakest HDMI
TM
signal level for short
transmission length. Try adjusting the signal level from 7 to 0 to find the optimal setting
for the HDMI
TM
over CAT5 transmission.
HARDWARE INSTALLATION
PERFORMANCE GUIDE
Performance rating
Type of category cable
Wiring
Shielding
CAT5
CAT5e
CAT6
Solid
Unshielded (UTP)
Shielded (STP)
Stranded
Unshielded (UTP)
Shielded (STP)
Termination
Please use
EIA/TIA-568-B
termination (
T568B
) at any time