Elem Garden Technic TDE24V33-LI, Перевод оригинальной инструкции, Страница: 64 / 73

64
Area of Cutting (Battery Duration)
The area of cut (battery duration) depends on lawn conditions, grass density, moisture content, grass length and
height of cut.
Switching the machine on and off frequently during cutting will also reduce the area of cut (battery duration).
To improve the area of cut (battery duration) it is recommended to cut more frequently, raise the cutting height
and walk at a normal pace
Charging Advice
With continuous or several repetitive charging cycles without interruption, the charger can warm up. This is not
meaningful and does not indicate a technical defect of the battery charger.
A significantly reduced working period after charging indicates that the battery is used and must be replaced.
Assembly
●
Do not connect the battery and/or the isolator key before product is completely assembled.
●
Ensure the cables are not trapped when folding/ unfolding top/bottom handles. Do not drop the
handle.
Adjusting the Cutting Height
●
Stop, release switch lever and wait until the motor stops before adjusting height . The blades continue
to rotate after the machine is switched off, a rotating blade can cause injury.
●
Caution – do not touch the rotating blade. For the first cutting of the season, a high cutting adjustment
should be selected.
●
The lawnmower can be set to 5 cutting heights between 25mm and 65mm.
●
Using the height of cut between 25mm will shorten the battery duration.
Blade Maintenance
●
Warning! Switch “off”, remove the isolator key, battery and grass box before adjusting or cleaning.
●
Always wear gardening gloves when handling or working near the sharp blades.
Turn the machine on its right side and inspect the blade; if blunt or damaged, replace.
Use the following procedure to remove and re-place the blade:
Hold the blade using gardening gloves (not provided) and use a spanner (not provided) to remove the blade bolt
Blade connector and blade
Fit the blade, blade washer and the blade bolt . Ensure that the blade is the correct way up and tighten the bolt
firmly. Ensure the screwdriver is removed before attempting to turn the machine on.
●
Do not lubricate blade or blade bolt during refitting.
Cutting grass I
Overload when mowing the engine.
The engine is equipped with a safety switch that is activated when the blade
jammed, clogged or the motor is overloaded. Turn off the machine when
this happens.
The safety switch will only reset when you release the shifter first
Remove all obstacles, and wait one minute, then restart your Machine , you
can reset the safety switch.
●
You Wear gardening gloves whenever you handle in the area of sharp
knives or work.
NOTE wait: If you reset the safety switch and the starting switch.