3). If the line is too short, pull on the nylon line and repeatedly press the button of spool (9) until
the line reaches the edge of the guard. Pull the other line until it reaches the edge of the guard.
WARNING.
For your own safety when adjusting the length of the line, avoid coming into contact
with the line cutting blade which is fixed to the guard. It is extremely sharp. Keep your hands
well away from this area.
FIXING THE HARNESS
Adjust the length of the harness so that the cutting tool is always parallel to the ground.
Attach the harness to the suspension ring.
Place the harness on your left shoulder by passing your head and your right arm inside.
Hold the tool to your right so that the protection is always in front of you.
SWITCHING ON AND OFF
1) Connect the plug to the supply.
2) To switch on, you need to push the safety lock-off button (4) and then actuate the switch
trigger (5).
3) To switch off, release the switch trigger.
WARNING.
The tool runs for approximately 5 seconds after it has been switched off. Let the
motor came to a complete stand still before setting the tool down.
EXTENDING THE CUTTING LINE
To extend the cutting line, press the spool onto the ground whilst the motor is turning and the
line will extend automatically. For most effective grass trimming, ensure the machine is
operation at full speed and then use slow shallow sweeps of the cutting line, ensuring that you
do not overload the machine by cutting too fast or cutting through heavy terrain.
TRIMMING
1) Make sure that the work area is free of rock, debris, lines and other foreign objects.
2) Start the tool before approaching the grass to be cut.
3) If you need to release the cutting line, please “bump” the spool button of the trimmer on the
ground to feed the line. If too much line is fed out and it projects beyond the guard edge it is
cut by the line cutting blade.
4) Cut the grass by swinging the tool from right to left and proceed slowly keeping the trimmer
inclined forwards at an angle of about 30.Light cuts are better than heavy cuts as they allow
the cut grass to fall away from the spool preventing the grass from clogging the spool.
5) Start cutting nearest the mains power source and work away from it to make it easier to avoid the cable.
