24
EN
Instruction Manual
SCPI Commands for Electronic Loads
Date: 23-07-2015
Attention!
The following command is only supported by the Ethernet card IF-E1B!
SYSTem:
COMMunicate:
NETwork
:MAC?
-><SRD> Query the MAC address of the Ethernet card
:IPADdress?
-><SRD> Query the actual IP address of the unit, which will be returned in the typical
format.
Example:
192.168.0.2
:IPADdress
<CHAR> Set IP address via commandwith comma seperated decimals.
This will only be effective if the unit is switched off and then on again.
:MASK?
-><SRD> Query the actual subnet mask address of the unit, which will be returned
in
the
typical
format.
Example:
255.0.0.0
:MASK
<CHAR> Set subnet mask via commandwith comma seperated decimals.
This will only be effective if the unit is switched off and then on again.
:GATEway?
-><SRD> Query the actual gateway address of the unit, which will be returned in
the
typical
format.
Example:
0.0.0.0
:GATEway
<CHAR> Set gateway address via command, with comma seperated decimals.
This will only be effective if the unit is switched off and then on again.
Example:
SYST:COMM:NET:IPAD
192,
168,
0,
2 Will set IP 192.168.0.2, if device is in remote control.
SCPI
Содержание IF-E1
Страница 17: ......