Elektro-Automatik 39 200 120, Руководство по эксплуатации

Страница: 20 / 28

Page 20
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
ea1974@elektroautomatik.de
PS 2000 B Triple Series
3.4.3.1 Menu “Settings”
This menu is for all settings related to the DC output values:
Group Description
Presets Allows for adjustment of the set values of voltage and current, alternatively to the adjustment
in the main screen of the display.
Protection Allows for adjustment of protection thresholds (here: OVP, OCP). These are the same
values as shown in the main display page, but here they are adjustable. Also see section
«3.3. Alarm conditions»
Limits Allows for adjustment of limits for set values. Also see section
«3.4.4. Adjustment limits»
3.4.3.2 Menu “About HW/SW...”
This menu page displays an overview of device relevant data such as serial number, article number and firmware
versions.
3.4.3.3 Menu “HMI Setup”
These settings refer exclusively to both control panels (HMI). Some of the settings are valid for both, some are
separate. Those being for both are only shown in the left HMI.
Element Description In right HMI?
Language Selection of the display language between German and English.
Default setting: English No
Backlight The choice here is whether the backlight remains Always on or if it should
be dimmed to 0% brightness when no input via push buttons or rotary knob
is done for 60 s. As soon as manual input is done, the backlight returns
automatically. The setting doesn’t apply to remote control, so the display
could remain dark as long as the device is remotely controlled.
Default settings:
Always on ”
No
Brightness Adjustment of the backlight brightness between 0% (almost black) and 100%
(maximum, clearly readable).
Yes
HMI Lock Setup
See «3.4.7 Control panel (HMI) lock» on page 22.
Default setting: Lock all
Yes
Enable PIN
Belongs to the HMI lock feature. Activates the PIN (personal identification
number) which has been set up with Change PIN .
Yes
Change PIN Belongs to HMI Lock . Define a PIN or change it. No
Lock HMI? Locks the HMI when Yes has been selected and after leaving the setup menu. Yes
3.4.3.4 Menu “Tracking”
This menu item and menu is only shown in the left-hand display of output 1. It’s used to activate or deactivate the
so-called tracking mode. For more information about this mode refer to section
«3.4.8. Tracking mode»
.