elektraLite LXE 700 Wash, Руководство пользователя

Страница: 8 / 19

-
７
- LXE700 wash
Projector DMX start address selection
All
LXE 700 washes
need be given a DMX starting address when using a DMX signal, so that the correct
LXE
700 Wash
responds to the correct control signals. This digital starting address is the channel number from
which
LXE 700 Wash
starts to “listen” to the digital control information sent out from the
Elektralite CP20
or
other DMX controller. The allocation of this starting address is done by setting the correct number on the
display located on the base of
LXE700 Wash
.
You can set the same starting address for all fixtures or group of fixtures, like all the
LXE700 Washes
in your
plot, or you can make different address for each individual fixture.
If you set the same address, all the fixtures will start to “listen” to the same control signal from the same
channel number. In other words, changing the settings of one channel will affect all the fixtures simultaneously.
If you set a different address, each unit will start to “listen” to the channel number you have set, based on the
quantity of control channels of the fixture. That means changing the settings of one channel will affect only the
selected fixture.
In the case of this
LXE 700 Wash
, which is a 24 channel fixture, you should set the starting address of the first
unit to 1, the second
LXE 700 Wash
to 25 (24 + 1), the third to 49 (25 + 24), and so on.
Note:
After switching on,
LXE 700 wash
will automatically detect whether DMX 512 data is received or not. If the data is received, the display will
show
"A.001"
or whatever the address is set to, like “
A.025”
If there is no data received at the DMX-input, the display flashes
"A001"
with
the actually set address. This situation can occur if:
- the 5 PIN XLR plug (cable with DMX signal from the controller) is not connected to the input of
LXE 700 Wash
.
or
- the controller is switched off or defective.
or
-
the cable or connector is defective