Eleiko 3060281-03, Инструкция по монтажу

Страница: 10 / 10

1. Mount the floor crossbar between the right hand side with the left hand side. Use 1st
and 3rd hole from the back. Pretension the bolts before the whole rack is up.
2. Mount the crossbar with ”Eleiko-brackets” in the top between the two uprights with
lasercutted numbers. Pretension the bolts before the whole rack is up.
3. Insert the weight suspension pins in the big holes of the upright in the back. Make
sure to use a rubber hammer to knock the bolts in through the upright in the back and
through the weight suspensions. (Don’t remove the small weld bump on the weight
suspension pin)
4.
Mount the chins handle to the crossbar center aligned.
Pretension the bolts before the whole rack is up.
Tightening torque is 197 Nm for M16. Make sure all bolts are tightened before putting
on the accesories.
5.
Hang the J-cups on at desired height.
6. Hang the safety arms at desired height.
7. Always use magnetic safety pins for the safety arms.
1
2
3
4
5
5
3
3
3
3
3
6
6
7
7