37
INSTALLATION INSTRUCTIONS
The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforce in his home country.
How to stick the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
Its installation has to be done carefully, in accordance with the illustration below.
Fitting - installing:
•
The cut out sizes are:
Reference
Glas dimension
Cut-size
PA6040VTC
590 x 520 mm
560 x 490 mm
•
The piece of furniture or the support in which the hob is to be fitted, as well as the edges
of furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
•
The mural rods of edge must be heat-resisting.
•
The hobs are classified as “Y” class for heat protection. Ideally the hob should be
installed with plenty of space on either side. There may be a wall at the rear and tall units
or a wall at one side.
On the other side, however, no unit or divider must stand
higher than the hob.
•
Ensure that there is a distance of 50 mm between the hob and the wall or sides.
•
Materials which are often used to make worktops expand on contact with water. To
protect the cut out edge, apply a coat of varnish or special sealant. Particular care must
be given to applying the adhesive joint supplied with the hob to prevent any leakage into
the supporting furniture. This gasket guarantees a correct seal when used in conjunction
with smooth work top surfaces.
•
Do not install the hob to the top of a non ventilated oven or a dishwasher.
•
If a drawer is placed under the hob, avoid putting into this drawer flammable objects (for
example: sprays) or non heat-resistant objects.
•
The safety gap between the hob and the cooker hood placed above must respect the
indications of the hood manufacturer. In case of absence of instructions respect a
distance minimum of 760 mm.
•
The wire connection must not be obstructed or fouled by, a working drawer or obstacles
contained within such drawer.
•
The installation of the hob in nonstationary sites (for example: boat, motor home) should
be undertaken by specialists.
•
WARNING
: Use only hob guards designed by the manufacturer of the cooking appliance
or indicated by the manufacturer of the appliance in the instructions for use as suitable or
hob guards incorporated in the appliance. The use of inappropriate guards can cause
accidents.
Stick the gasket (2) two millimetres
from the external edge of the glass,
after removing the protection sheet (3).
