Short leg
negative
-
Long leg
positive
+
1
2
1
Using 2 short wires (3cm)
connect the 2.1mm power
jack connector to the – and
+ pads of the board.
Make sure that the short
lead goes to – and the long
lead to + this will make the
power supply centre
negative (boss style).
If you want to use a
“normal” 9 to 12Vdc centre
positive adapter, just invert
the connection.
You will need to solder this
power jack again when
boxing the pedal, so don’t
lose time make the
soldering perfect just yet.
Using two short wires (3cm)
connect the momentary
footswitch to the connector
J12.
3
3
3
Put the 2 LEDs through the
holes, they will stay in place
without the need of
soldering.
The LEDs have to be soldered
once the PCB goes into the
enclosure, so
DON’T SOLDER THE LEDs
YET.
*
*
It is better to break the
mousebites (separate the
PCB) later, in Step 10
STEP 6 – Finish the Assembly:
Top side:
Bottom side: