Electronics Line Penta, Руководство пользователя

Страница: 8 / 10

-8-
3.8: Event Logs
The event logs record events that the system has undergone since the last arming. If
any events have been recorded in either event log, the System LED flashes until the
relevant event log has been viewed. In the event that a trouble condition still exists, the
System LED continues to flash until the condition has been remedied.
Emergency/Trouble Event Log
Zone tamper, bell trouble, keypad trouble, keypad tamper or any of the three distress
key alarms are registered in the Emergency/Trouble event log. If atroube event occurs,
contact your installer.
To view the Emergency/Trouble event log:
1. Press
Q
, 2 ; the various trouble conditions are indicated by the zone LEDs.
The following is a summary of the trouble condition that each LED indicates:
1 – System Trouble 2 - Alarm from P key
3 - Alarm from F key 4 - Alarm from E key
2. Press # to exit the event log. Note: In the event of system trouble, contact your
installer.
Zone Alarm Event Log
The Zone Alarm event log displays the zones from which an alarm was generated since
the system was last armed.
To view the Zone Alarm event log:
1. Press
Q
, 3; an alarm from a specific zone is indicated by the corresponding zone
LED.
2. Press # to exit the event log.
Both logs are automatically reset when the system is next armed.
3.9: Follow-me
If your system is not monitored by a central station, either the ‘Follow-me’ or ‘Voice
message’ feature is used to inform you that an alarm has occurred.
When using Follow-me, the Penta dials the telephone number programmed by the
installer and sounds two beeps. After hearing the two beeps, pressing 3, 6, 9 or # on
the telephone sounds a number of tones to indicate exactly which type of alarm has
occurred. The number of tones indicates the type of alarm generated.
1 tone
Alarm from zone 1
1 long
F key alarm
2 tones Alarm from zone 2 Tone
3 tones Alarm from zone 3 2 long E or P key alarms
4 tones
Alarm from zone 4
Tones
or system trouble
After the alarm tones have been sounded, pressing 3, 6, 9 or # on the telephone either
causes the panel to hang up or, if additional alarms have occurred, sound another set
of alarm tones.
Note: In the event of system trouble, contact your installer.
Alternatively, the Voice message feature plays a recorded message to announce that
an alarm has occurred. Press 3, 6, 9 or # on the telephone to acknowledge that you
have received the message.