EL-2603
English
The EL-2603 is a brand-name smoke detector and transmitter designed for use with Electronics Line
3000’s supervised wireless range of receivers. The EL-2603 sends a status transmission to the
receiver every hour to indicate that the transmitter is functional.
Installation Instructions
The following procedure explains the
installation of the EL-2603 wireless smoke
detector and its registration to the receiver.
For further information regarding the smoke
detector’s location, test procedures,
maintenance and specifications, refer to the
manufacturer’s installation instructions
provided with this product.
1. Open the cover by lifting the opening tab
while firmly holding the base with your
other hand.
2. Push the cover backwards to separate
the cover from the base.
3.
Install a 9V battery into the detector’s
battery snap.
4.
Insert the Test jumper; the EL-2603
enters Test mode and the LED flashes
every few seconds
5. While the EL-2603 is in Test mode, set
the receiver to Registration mode and
make sure that the EL-2603’s LED lights
up at least twice. The receiver allocates
a transmitter number to each registered
unit. Write this number and the number
of the zone on the sticker provided. Affix
the sticker inside the front cover for
future reference. Note: Alternatively, the
EL-2603 can be registered to the
receiver by manually entering the
transmitter's serial number.
6.
After registration, remove the Test jumper
and place it over one pin for storage
7. Before permanently mounting the unit,
test the transmitter from the exact
mounting position. If necessary, relocate
the EL-2603 to a better position.
8. Attach the mounting base to the ceiling using the screws provided.
9. Replace the cover onto its hinges and close the cover until it snaps together with the base.
Technical Specifications
Antenna: Built-in Internal Whip
Frequency: 868.35, 433.92 or 418MHz FM
Current Consumption: 30mA (transmission)
20
μ
A (standby)
Power: 9V Alkaline Battery
RFI Immunity: 40V/m
Operating Temperature: 0-60°C
Figure 1: EL-2603 (cover open)/
Figure 1: EL-2603 (couvercle ouvert)/Figura 1: EL-2603 (tapa abierta)
1. Opening
Tab/Lanière
d’ouverture/ Lengüeta de
apertura
2. LED Indicator/Indicateur de
LED/
Indicador LED
3. Test
Jumper/Cavalier
Test/Jumper de Test