M40/50RF System September 2011, rev 2 - DRAFT
© 2011 Electronic Solutions, Inc.
Page 2 of 7
Join the Remote to the Hub Motor
(a)
“Wake up” the remote if no LEDs are lit (asleep).
Press and release the UP or DOWN button.
Green “preset” LED is solid (Network Search Mode).
4
(b) Put Hub motor into Network Invite
Mode.
NOTE: if the Yellow LED on the motor is
flashing, Skip to Step 2 (d).
Press and release the Center button once.
(c) On the Hub motor.
Yellow LED flashes for 60
seconds to indicate new
devices may join.
(d) Remote automatically joins the Hub and forms a
network.
Green “preset” LED blinks once, and Hub motor jogs once, then jogs
twice.
(e) Remote is in Setup Mode.
Red LED under “preset” is solid, and Yellow LED under Group 1 is solid.
The UP and DOWN buttons are flashing (indicates no end limits are set).
Toggle Motor Direction
— Check the motor travel direction using the remote.
(a) Verify travel direction.
Press the UP or DOWN button.
If the shade moves as expected,
skip to Step 4.
(b) Toggle the motor direction.
Simultaneously press and hold the UP and DOWN buttons
for 5 seconds until the motor jogs once.
Motor direction is now reversed.
(c) Verify the direction change.
Press the UP or DOWN button.
Set Limits
(a) Adjust shade to Upper limit position.
Press and hold the UP button.
(b) Set the Upper end limit.
Simultaneously press and hold STOP and UP until
motor jogs twice (approximately 2 seconds).
(c) Upper end limit is set.
Yellow LED on UP button turns
off.
