Part No. 182559 R0102A
Printed in China © 2002 ICON Health & Fitness, Inc.
Maintenance and Troubleshooting
Regularly check the scooter and make sure all parts are
properly tightened. If the scooter does not function prop-
erly, follow the steps below. If assistance is needed, call
our Customer Service Department toll-free at 1-800-999-
3756. IMPORTANT: Move the on/off switch to the off
position before performing any of the steps below.
Symptom 1—The motor does not start when the start
switch is pulled.
1. Make sure the on/off switch is in the on position.
2. Make sure the batteries are charged.
3. Make sure the brake handle is not being pulled.
4. To protect the motor, the PTC resistor has tripped;
allow the scooter to cool down.
Symptom 2—The batteries discharge quickly.
1. Make sure the tires are inflated to the pressure listed
on the sides of the tires.
2. Use the scooter on level, smooth surfaces. Avoid
using the scooter on grades steeper than 5%.
3. Charge and store the batteries at temperatures
between 50°F and 100°F (10°C and 38°C).
4. If the batteries still discharge quickly, new batteries
may be needed. Refer to page 6 for instructions.
Symptom 3—The brake is too loose or too tight.
1. Locate the locknut and adjustment barrel on the
brake handle. Turn the locknut counterclockwise to
loosen it. Next, turn the adjustment barrel counter-
clockwise to tighten the brake or clockwise to loosen
it. Then, turn the locknut clockwise to retighten it.
Repeat until the hand brake is properly adjusted.
If the hand brake requires further adjustment, the
lower end of the brake cable can be adjusted.
Remove the six M8 x 23.5mm bolts from the deck,
lift off the deck, and locate the adjustment barrel and
locknut near the lower end of the brake cable. Using
a small open-end wrench, loosen the locknut. Next,
turn the adjustment barrel counterclockwise to tight-
en the brake or clockwise to loosen it. Then, retight-
en the locknut. Repeat until the hand brake is proper-
ly adjusted. When the hand brake is properly adjust-
ed, reattach the deck with the six bolts.
Symptom 4—The drive belt slips.
1. Locate the M10 nylon locknuts and the M6 nylon
locknuts near the rear wheel. Loosen the M10 nylon
locknuts. To tighten the drive belt, turn both M6 nylon
locknuts clockwise. Make sure the rear wheel is
straight and retighten the M10 nylon locknuts. Repeat
this procedure until the drive belt no longer slips.
Symptom 5—The quick release is too loose or too tight.
1. If the quick release doesn’t hold the stem tightly, or if
the quick release cannot be closed, refer to step 2 on
page 4 for adjustment instructions.
Barrel
Locknut
M10 Nylon
Locknut
M6 Nylon
Locknuts
M10 Nylon
Locknut
Barrel
Brake Cable
M8 x
23.5mm
Bolts
Locknut
Deck
