Electrolux WOL6035CN, Руководство пользователя

Страница: 4 / 24

4
www.electrolux.com
1. RECOMMENDATIONS
AND SUGGESTIONS
• The Instructions for Use apply
to several versions of this ap-
pliance. Accordingly, you may
find descriptions of individual
features that do not apply to
your specific appliance.
• The manufacturer will not be
held liable for any damages
resulting from incorrect or
improper installation.
• The minimum safety distance
between the cooker top and
the extractor hood is 650
mm (some models can be
installed at a lower height,
please refer to the paragraphs
on working dimensions and
installation).
• Check that the mains voltage
corresponds to that indicated
on the rating plate fixed to the
inside of the hood.
• For Class I appliances, check
that the domestic power sup-
ply guarantees adequate
earthing. Connect the extrac-
tor to the exhaust flue through
a pipe of minimum diameter
120 mm. The route of the flue
must be as short as possible.
• Do not connect the extractor
hood to exhaust ducts carry-
ing combustion fumes (boil-
ers, fireplaces, etc.).
• If the extractor is used in con-
junction with non-electrical
appliances (e.g. gas burn-
ing appliances), a sufficient
degree of aeration must be
guaranteed in the room in
order to prevent the backflow
of exhaust gas. The kitchen
must have an opening com-
municating directly with the
open air in order to guarantee
the entry of clean air. When
the cooker hood is used in
conjunction with appliances
supplied with energy other
than electric, the negative
pressure in the room must not
exceed 0,04 mbar to prevent
fumes being drawn back into
the room by the cooker hood.
• In the event of damage to
the power cable, it must be
replaced by the manufacturer
or by the technical service de-
partment, in order to prevent
any risks.
• If the instructions for installa-
tion for the gas hob specify
a greater distance specified
above, this has to be taken
into account. Regulations
concerning the discharge of
air have to be fulfilled.
• Use only screws and small
parts in support of the hood.
Warning: Failure to install the
screws or fixing device in ac -
cordance with these instruc-
tions may result in electrical
hazards.
• Connect the hood to the mains
through a two-pole switch
having a contact gap of at
least 3 mm.