![background image](http://html.mh-extra.com/html/electrolux/washer/washer_service-manual_99111050.webp)
SOI/DT 2005-01 dmm
599 36 82-56
50/65
12 DEMO
MODE
A special demo cycle enables these appliances to be demonstrated in stores without the need for
connection to the plumbing system. Any programme on the machine can be selected and, after the start
button is pressed, the appliance performs certain phases in that programme (and not those that cannot be
executed, such as water fill, draining and heating).
The cycle is carried out in the following way:
ª
the door lock unit operates normally (the door is locked during operation and can be opened at the end
of the cycle or during a pause)
ª
motor: all low speed movements are performed; pulse and spin operation is disabled
ª
the water fill solenoid valves and drain pump are disabled
ª
display: since the phases in the demo cycle are very quick (one second corresponds to one minute of
a real cycle), the time until the end of the cycle decreases by one unit every second. It must be
remembered that the “time until end of the cycle” does not always correspond to the real time of a
cycle.
ª
alarms: for safety reasons, the following alarm families are enabled: E40 (door closure), E50 (motor)
and E90 (communication between circuit boards/configuration).
12.1 Selecting demo mode
ª
Switch off the appliance
ª
Press buttons
1
and
5
(or
2
and
6
) at the same time; holding these two buttons down, turn the
programme selector
two positions to the right (i.e. clockwise)
.
ª
Hold down buttons
1
and
5
until the LEDs begin to flash (5 seconds approx.).
The time required for running a cycle in Demo mode depends on the programme chosen.
12.2 Exiting demo mode
ª
Switch off the appliance to exit Demo mode.