Problem
Possible cause
Possible solution
The appliance makes
an unusual noise.
Incorrect level of the appli-
ance.
Adjust the level of the appliance. Refer
to 'Installation'.
You did not remove the pack-
aging and/or the transit bolts.
Remove the packaging and/or the trans-
it bolts. Refer to 'Installation'.
The load is very small.
Add more laundry in the drum.
The appliance fills with
water and drain imme-
diately.
The end of the drain hose is
too low.
Make sure that the drain hose is in the
correct position.
The cycle is shorter
than the time dis-
played.
The appliance calculates a
new time according to the
laundry load.
See the ‘Consumption Values’ chapter.
The cycle is longer
than the time dis-
played.
An unbalanced laundry load
increases the duration time.
This is a normal behaviour of the appli-
ance.
The washing results
are not satisfactory.
The detergent you used was
not sufficient or correct.
Increase the detergent quantity or use a
different one.
You did not remove the stub-
born stains before you wash
the laundry.
Use special products to remove the
stubborn stains.
Incorrect temperature was set.
Make sure that you set the correct tem-
perature.
Too much laundry load.
Decrease the laundry load.
After the check, activate the appliance. The
programme continues from the point of in-
terruption.
If the problem occurs again, contact the
service centre.
If the display shows other alarm codes,
contact the service centre.
SERVICE
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ...
Refer to the information supplied with this
appliance for guarantee condition and point
of contact. The information to give to the
service is on the rating plate.
We recommend that you write the information
here:
Model
(MOD.)
..................
Product number
(PNC)
..................
Serial number
(S.N.)
..................
INSTALLATION
FIXING PLATE KIT (4055171146)
Available from your authorized dealer.
If you install the appliance on a plinth, se-
cure the appliance in the fixing plates.
Follow the instructions supplied with the kit.
UNPACKING
1. Use the gloves. Remove the external
film. If necessary, use a cutter.
electrolux
21