Electrolux U24226 ERC3709, Инструкция пользователя

Страница: 8 / 16

8
Electrolux 818 21 42-01/1
To change the light bulb
The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
Press the spring together and pull the grille
downward at the same time.
Use a bulb of the same type, E14 socket, maximum
rating of 25 W.
When the appliance is not in use
Disconnect the appliance from electricity supply .
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.
If the appliance is left on, e.g. while on holiday, ask
somebody to check it once in a while to prevent the
food inside from spoiling in case of a power failure.
Something Not Working
Before contacting your local Service Force Centre check the following points:
Symptom Solution
The temperature is too high inside the
refrigerator. Set a lower temperature.
Put food products in the right place inside the refrigerator. See
the chapter "Temperature inside the refrigerator".
Distribute the food products to allow cold air to circulate
around them.
Make sure that the door is completely closed and that the
rubber door seal is complete and clean.
The temperature where the cabinet is placed is not within its
operating limits. See installation section.
It is too cold inside the refrigerator. Set a warmer temperature.
See the section"To start the fridge and thermostat control".
There is water on the cooling plate inside
the refrigerator. This is normal. During automatic defrosting, frost thaws on the
cooling plate.
Water is running inside the refrigerator. Clean the water drain and drain hole inside the refrigerator
using a piece of flexible curtain wire.
Food products could have been placed near the rear of the
appliance, preventing the water from running into the drain.
Water comes out on the floor. Place the drain hose at the back of the appliance above the
drain bowl. See the chapter "Before use"
The compressor operates continuously. Set a warmer temperature.
Make sure that the door is completely closed and that the
rubber door seal is complete and clean.
The temperature where the cabinet is placed is not within its
operating limits. See installation section.
The cabinet does not operate at all.
Cooling or interior light does not
operate. No indicator lamps light. The appliance is not switched on.
Power does not reach the appliance. (Try connecting another
electrical device to the power outlet.)
The fuse has blown.
The power plug is not properly connected.