38
Making the appliance level
3
Automatic foot:
The rear foot on the left-hand side of your washing ma-
chine is built as a shock absorbing foot, which is why the appliance gives in
the back left-hand corner if put under load. The automatic foot guarantees
that the appliance does not move even at high spin speeds. Basically the
automatic foot does not need to be set.
The four feet of the appliance are pre-ad-
justed.
Large degrees of unevenness can be
compensated for by individually adjust-
ing the height adjustable screw feet.
Use the special spanner supplied to do
this.
Important!
Do not use pieces of wood,
cardboard or such like to level out une-
venness in the floor, but adjust the height
adjustable screw feet instead.
Electrical connection
Details about the voltage, type of supply and the fuses required are to be
found on the rating plate. The rating plate is next to the doorway.
Connecting to the water supply
Permitted water pressure
The water pressure must be at least 1bar (=10N/cm
2
=0.1MPa) and may be
a maximum of 10bar (=100N/cm
2
=1MPa).
–
If more than 10bar: Connect a pressure reduction valve.
–
If less than 1bar: Disconnect the appliance end of the inlet hose from the
solenoid inlet valve and remove the flow meter. (In addition remove the fil-
ter using pointed pliers and take out the rubber gasket behind it.) Re-in-
sert the filter.
