31
2.
Connect the hose with the angled con-
nection to the machine.
Important!
Do not place the inlet hose down-
wards. Angle the hose to the left or
right depending on the position of your
water tap.
3.
Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4.
Connect the hose to a tap with a
3/4” thread.
Always use the hose supplied with the
appliance.
Installation should comply with local wa-
ter authority and building regulations’ re-
quirements.
A minimum water pressure of 0.05 MPa
(0.5 bar) is required for safe operation of
the appliance.
If you cannot make the cold water con-
nection direct from the rising mains, you may be able to operate the appli-
ance from your cold water storage system.
There should be a minimum distance of 5.02m (16.5 ft) between the appli-
ance’s inlet and the bottom of the water storage tank.
Aqua Control
The inlet hose is provided with a water
stop device, which protects against dam-
age caused by water leaks in the hose
which could develop due to natural age-
ing of the hose. This fault is shown by a
red sector in the window „
A
”. Should this
occur, turn the water tap off and refer to
your Service Centre to replace the hose.
