4
To feed the nylon line
1. Press and hold the two latches
(H)
.
2. Gently pull the line until it reaches the line cutter.
3. Release the two latches. Check that the spool is
locked in position.
4. If too much line has been fed out, press the two
latches and turn the spool anti-clockwise until the
line is at the desired length.
To remove spool
1. Press and hold the two latches.
2. Pull spool out of spoolholder
(J)
.
When refitting the spool
1. Keep all areas of the spool and spoolholder clean.
Failure to do so may prevent the spool from being
securely located in the spoolholder.
2. Make sure the line is placed through the slot in the
spoolholder
(K)
.
3. Place spool into spoolholder and press down into
place.
4.
Check that the spool is correctly fitted by trying
to remove the spool without depressing the
latches (K1).
To replace nylon line
Replacement line is available from most Electrolux
Outdoor Products stockists. You can buy it either as
spool and line complete or as nylon line only.
To replace spool and line complete
1. Remove old spool.
2. Release line from cleat. Unwind approximately
100mm of line and feed through slot in spoolholder
(K)
.
3. Re-fit spool into spoolholder. Check that the spool is
locked in position.
To replace nylon line on spool
1. Take approximately 5 metres of line line and insert
into one of the line lock holes in the spool
(L)
.
2. Wind line onto spool in the direction of the arrows on
the top of the spool. Care should be taken to ensure
that the line is neatly coiled on the spool
(L)
.
3. Leave approximately 100mm of line unwound and
feed through slot in spoolholder
(K)
.
4. Replace spool into spoolholder.
Ensure spool is correctly fitted.
Remember! Your trimmer is designed to use only
nylon line with a maximum diameter of 1.5mm. Use
only genuine Electrolux Outdoor Products nylon line.
Fault Finding Hints
WARNING! Disconnect from the mains electricity
supply before attempting any maintenance or
adjustment.
1. Line too short.
Feed out line.
2. Line broken inside of spoolholder.
Remove spool and re-thread line.
3. Line jammed on spool.
Remove spool and rewind line to remove crossed loops.
4. Poor performance.
Ensure the inside of the spoolholder is clean and
free from debris.
5. Line snaps continuously.
Use only tip of nylon line to trim. If symptoms still
persist, change spool and line.
6. Line will not pull out.
Check that line has been released from cleat.
7. IF FAULT PERSISTS
Contact Electrolux Outdoor Products Customer
Service. Telephone 01325 300303.
Manual Line Feed System
Line cutter
Spool
Spoolholder
Latches
Slot
H
J
K
L
Line lock
hole
Cleat
K1
