Electrolux JANITOR Z1516, Инструкция по эксплуатации

Страница: 5 / 8

5
Unpacking the Unit
• Unpack the unit and check that all items that
should be included are present. Immediately
notify your dealer or our Customer Service
department if you find any damage or if any
items are missing.
• Save the original packing carton, since you
can use it for storing the unit and might need
it to return the unit to your dealer or an
Electrolux Customer Service engineer for ser-
vicing.
Assembling the Unit
• Fig. A: Open the latches (8), lift off the motor
housing (7), and remove the accessories from
inside the tank.
• Fig. B: Insert the pins (17) into the holes in the
base of the tank (1) and then press the castors
(9) and pins in the holes until the necks of the
castors are flush with the base of the tank.
Set the tank (1) down on the castors and
check whether the castors are correctly seated
and working properly.
• Fig. C:
a
Mounting of parking mechanism
(19).
b
Mounting height of locking mechanism
is to be determined depending on the size of
nozzles to be inserted (20).
• Fig. D: Grasp the paper dustbag (12) by the
edges of its cardboard flap, press the bag
firmly onto the inner side of the hose fitting (2),
and then spread the paper dustbag out
against the inner wall of the tank (1).
• Fig. E: Place the cartridge filter in an upright
position on the motor flange and gently but
firmly slide it into place on the filter mounting.
The pre-mounted retaining clips automatically
snap into place, thus securing the cartridge
filter.
• Fig. A: Set the motor housing (7) onto the tank
(1) such that the switch (3) is above the hose
fitting and latch down both latches (8).
• Fig. F: Align the index mark on the suction
hose (5) on that on the hose fitting (2) and then
insert the suction hose (5) into the hose fitting
(2) and press it home until the button snaps
into the hole. You may now install the acces-
sories you intend to use on the free end of the
hose. To remove the suction hose (5), simply
give it a twist it and pull off the fitting (2) while
continuing to twist it.
• Fig. G: Cable storage.
CAUTION
Never vacuum without the cartridge filter
installed.
Cleaning the cartridge filter (13)
Dismantle the cartridge filter (Fig.
E
).
You can clean it by simply brushing off the dust,
whilst holding it at its handle over a garbage bin.
If necessary, you can also clean it under a light
flow of running water. In this case, it must be
fully dried before being used again.
Replacing the Dustbag
Replacing the paper dustbag (12)
• Fig. C: Switch off the unit, unplug the cable,
and remove the motor housing (7) from the
tank (1). Grasp the cardboard flap on the
paper filter bag (12), pull if off the hose fitting
(2), press a new dustbag onto the hose fitting
(2), and replace the motor housing (7).
Cleaning the Unit
• Switch off the unit and unplug its cable. Do
not use abrasive or aggressive cleaning
agents. Wipe the motor housing and tank
clean using a damp cloth.
• Never use acetone, acids, or solvents for
cleaning, since they will attack the units finish
and components.
• Never immerse the unit in water.
• Replace the dustbag at regular intervals.
Unplug the unit before proceeding to replace
the dustbag.
Disposing of the Unit
• Units that are no longer serviceable may be
brought to a public collection point or refuse
dump for disposal.
• Normal household dust may be disposed of
along with other household waste.