Electrolux ICF100E, Инструкция по эксплуатации

Страница: 4 / 12

4
POSITION
Place the freezer horizontally on a firm
surface, resting on all four plastic feet.
Use a wooden block or similar object
to compensate for any bumps/holes in
the surface.
The room should be dry and
adequately ventilated.
If the room temperature exceeds
32°C, or falls below freezing point, the
freezer will not function as it should.
Do not place the freezer close to
sources of heat, radiators, chimneys,
etc., and do not place the freezer in
direct sunlight.
If the freezer has been handled
standing on end it should be allowed to
stand in normal position for about 12
hours before switching it on.
Please ensure that when the appliance
is installed it is easily accessible for the
engineer in the event of a breakdown.
ELECTRICAL REQUIREMENTS.
Before switching on, make sure that the
voltage of your electricity supply is the
same as that indicated on the rating plate,
located inside the lid.
For your convenience, this appliance comes
complete with either a moulded-on or re-
wireable 13 amp (BS1363) plug, protected
by a 13 amp ASTA approved (BS1362) fuse.
In the event of having to change the fuse
in the plug supplied, a replacement 13
amp ASTA approved (BS1362) fuse must
be used.
In the case of a moulded-on plug, the fuse
cover MUST be refitted after changing
fuse. If the fuse cover is lost or damaged
the plug MUST NOT be used until a
replacement is obtained.
Warning:
This appliance must be earthed.