Electrolux GWH 11 NanoPlus EU, Руководство пользователя

Страница: 7 / 16

ENGLISH
7
Model of appliance type B11BS
heater
The heater is equipped with an exhaust
security thermostat.
If the exhaust outlet is not completely open,
the thermostat is activated. Once the gas
valve is closed, the heater will have an ignition
once again after it has cooled off.
The activated temperature of anti-block
protection thermostat is 75°C±5°C. When
protection happens, electric circuit is cut and
unit doesn’t work. The recovery temperature of
the anti-block thermostat is 50°C±5°C. When
it is recovered, the electric circuit is on. The
unit works right. If the system stops working
in 2 minute when the flue pipe is blocked, it
means anti-block function is in protection. If
not, please contact professional people to fix
it following the rules of EN 26 standard.
Installation
• The heater can only be installed inside a
room.
• No installation of the heater in frost places.
• Keep the heater with good ventilation.
• No cables or electric appliances can
be placed on the heater. Keep the
heater away from heat sources such as
hearth. Please fulfill the cleaning and the
maintenance for the heater according to
relevant requirements of interval.
• Please maintain a certain distance
between vent-pipe and the ceiling of the
room or other decorative objects.
• Inflammable materials are banned from
being placed less than 500mm away from
the heater. If necessary, please install an
outer insulating layer.
• The heater must be installed onto a vertical
wall in a correct vertical way.
• The maximum pressure for which the
appliance is designed, stating that even
with the effects of water dilation, the water
pressure in the appliance shall not exceed
this value.
• The air flow in the circumstance around the
gas water heater should be according to
the follows
Model Gas category
Air con-
sumption
(m
3
/h)
GWH 11 NanoPlus EU I2H
I3P(37)
I3B/P(30)
I3+(28-30/37)
21-33
GWH 14 NanoPlus EU I2H
I3P(37)
I3B/P(30)
I3+(28-30/37)
26,8-42
Installation order
• Confirm the drilling position according to
the installation scheme or installation chart
in the Speciation Table.
• Open the close cover of the heater and
pull out the operation button.
• Screw off the fixed bolts in the lower part
of the casing and then take off the casing.
• Fix the heater.
• Take off the plastic hoods used for
connections of the heater.
• Install the connectors.
• Mount the casing and then replace the
operation button.
Minimum distance/ ventilation
The water heater is controlled by water flow
rate to achieve on/off. Minimum starting water
pressure is 0.3bar When there is water going
through the water operated gas valve (water
flow rate sitisfied with minimum water flow
rate refers to specification table), the ignition
will start to work and the gas valve will be
energized.The un it will be ON mode.
When the water flow is cut, the water gas
valve will cut the gas valve as well. the unit will
stop working.