Electrolux GK65TSF, Руководство пользователя

Страница: 10 / 12

To remove the dirt:
1. – Remove immediately: melted plas-
tic, plastic foil, and food with sugar. If
not, the dirt can cause damage to
the appliance. Use a special scraper
for the glass . Put the scraper on the
glass surface at an acute angle and
move the blade on the surface .
– Remove after the appliance is
sufficiently cool:
limescale rings ,
water rings, fat stains, shiny metallic
discolorations. Use a special cleaning
agent for glass ceramic or stainless
steel.
2. Clean the appliance with a moist cloth
and some detergent.
3. At the end rub the appliance dry
with a clean cloth.
WHAT TO DO IF…
Problem Possible cause and remedy
You cannot activate the appli-
ance or operate it. • Activate the appliance again and set the heat setting in 10 sec-
onds.
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• The Child Safety Device or the Lock or Stop+Go operates. See
the chapter Operating instructions.
• There is water or fat stains on the control panel. Clean the con-
trol panel.
A Sound operates and the ap-
pliance deactivates.
A sound operates when the ap-
pliance is deactivated. You put something on one or more sensor fields. Remove the ob-
ject from the sensor fields.
The appliance deactivates.
You put something on the . Remove the object from the sen-
sor field.
The residual heat indicator
does not comes on. The cooking zone is not hot because it operated only for a short
time. If the cooking zone should be hot, speak to the service cen-
tre.
The Automatic Heat Up func-
tion does not operate. • There is still residual heat on the cooking zone. Let the cooking
zone become sufficiently cool.
• The highest heat setting is set. The highest heat setting has the
same power as the Automatic Heat Up function.
You cannot activate the outer
ring. Activate the inner ring first.
The sensor fields become hot. The cookware is too large or you out it too near to the controls.
Put large cookware on the rear cooking zones if it is necessary.
There is no signal when you
touch the panel sensor fields. The signals are deactivated. Activate the signals (see OffSound
Control).
comes on
The Automatic Switch Off operates. Deactivate the appliance and
activate it again.
and number comes on.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some
time. Disconnect the fuse from the electrical system of the house.
Connect again. If
comes on again, speak to the service cen-
tre.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the glass surface) and an error message that
comes on.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
service technician or dealer will not be free
10 electrolux