Electrolux EWT 8020 W, Руководство пользователя

Страница: 6 / 20

The exterior
Use warm soapy water to clean the exterior of the
appliance. Never use alcohol, solvents or similar
products.
Dispenser box
To clean, proceed as follows :
1 2 3 4
5 6
Object trap
Regularly clean out the object trap which is located
at the bottom of the drum :
Water inlet filters
To clean, proceed as follows :
1 2
Operating Problems
Numerous checks were carried out on your appli-
ance before it left the factory. However, should you notice a malfunction, please refer to the sections
below before contacting the after-sales service.
Problems Causes
The washing machine
doesn’t start or doesn’t
fill: • the appliance isn’t plugged in correctly, the electrical installation isn’t
working,
• the lid of your appliance and the drum shutters aren’t closed firmly,
• the programme start command hasn’t been properly selected,
• there is a power failure,
• the water supply has been cut off,
• the water inlet tap is closed,
• the water inlet filters are dirty,
• a red tab appears on the water inlet hose.
The appliance fills but
empties straight away: • the drainage U-piece is fixed too low (see installation section).
The washing machine
doesn’t rinse or doesn’t
empty: • the drain hose is blocked or bent,
• the drainage filter is obstructed,
• the out of balance detector has been activated : washing is unevenly
distributed in the drum,
• the “Drain” programme or “Night Silence Plus” or “Rinse hold” option
have been selected,
• the height of the drainage U-piece is unsuitable.
You have found water
around the washing ma-
chine: • too much detergent has caused foam to overflow,
• the detergent is unsuitable for machine washing,
• the drainage U-piece isn’t attached correctly,
• the drainage filter hasn’t been put back in place,
• the water inlet hose is leaking.
Wash is unsatisfactory: • the detergent is unsuitable for machine washing,
• there is too much washing in the drum,
• the wash cycle is unsuitable,
• there isn’t enough detergent.
6 electrolux