Electrolux EWT 1466 HDW, Руководство пользователя

Страница: 20 / 24

Problem Possible solution
You cannot open the
appliance lid. Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in
the drum.
The appliance makes
an unusual noise. Make sure the levelling of the appliance is incorrect. Re-
fer to 'Installation'.
Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation'.
Add more laundry in the drum. The load may be too
small.
The appliance fills with
water and drain imme-
diately. Make sure that the drain hose is in the correct position.
The hose may be too low.
The washing results
are not satisfactory. Increase the detergent quantity or use a different deter-
gent.
Use special products to remove the stubborn stains be-
fore you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
You cannot set an op-
tion. Make sure that you press only the wanted touchbut-
ton(s).
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
Service. If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the Serv-
ice.
12. TECHNICAL INFORMATION
Dimensions Width / Height / Depth 400 / 850 / 600 mm
Total depth 600 mm
Electrical connection: Voltage
Overall power
Fuse
Frequency 230 V
2200 W
10 A
50 Hz
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture
IPX4
Water supply pressure Minimum 0,5 bar (0,05 MPa)
Maximum 8 bar (0,8 MPa)
20 www.electrolux.com