Personalisation
Child safety
This option provides two types of locking :
• if the option is activated after the cycle has star-
ted, no changes to the options or programme is
possible.
The cycle runs and you must deactivate the op-
tion to run a new cycle.
• if the option is activated before the cycle has
started, the appliance cannot be started.
To activate child safety, turn appliance on and
press “Rinse plus”
and “Delay start”
simul-
taneously until the confirmation symbol
shows
on in the display. The appliance memorises the
selection of this option. To deactivate child safety,
repeat the process.
Audible signal
When the audible signal is activated, it sounds
when a button is pressed, at the end of the pro-
gramme, to indicate a fault.
To deactivate, turn appliance on and press “Pre-
wash”
and “Rinse plus”
simultaneously until
the beep sounds. The signal is only active if alarm
sounds. To reactivate it, repeat the same process.
How to run a wash cycle?
Using for the first time
• Ensure the electrical and water connec-
tions comply with the installation instruc-
tions.
• Remove the polystyrene insert and all other
items inside the drum.
• Run an initial wash cycle at 90°C, without any
washing but with detergent to clean the water
tank.
Daily use
Loading washing
• Open the lid of the
appliance.
• Open the drum by
depressing the
locking button A:
The two shutters
unlock automati-
cally.
• Load the washing,
close the drum and
the lid of your
washing machine.
Warning!
Before closing the lid of your
appliance, ensure that the drum is properly
closed :
• When the two shutters are closed,
• locking button A released.
Proportioning of detergents
Pour the amount of washing powder into the
washing
and prewash
compartments if you
have selected the “prewash” option. Pour fabric
softener into the compartment if necessary.
Selection of desired programme
Turn the programme selector to the required pro-
gramme. The “Start/Pause” pushbutton flashes
green.
If you turn the programme selector to another pro-
gramme while a cycle is in progress, the appliance
will ignore the new selected programme. “Err”
A
flashes and the “Start/Pause” pushbutton flashes
red for a few seconds.
Selecting the temperature
Press the “Temperature” pushbutton repeatedly
to increase or decrease the temperature if you
want your washing to be washed at a different
temperature to the one selected by the appliance
(see “Programmes table”). The
symbol means
a cold wash.
Selecting the spin speed
Press the “Spin”
pushbutton to change the spin
speed, if you want your washing to be spun at a
different speed to the one selected by the appli-
ance. can also select “No spin” , “Rinse hold”
or “Night cycle plus”
1)
.
The maximum spin speeds are :
for Cottons, Eco : 1300 rpm, for Wool : 1000 rpm,
for Synthetics, Shirts, Easy iron : 900 rpm, for Del-
icates, Blanket : 700 rpm.
At the end of the programme, if you have selected
“Rinse hold”
or “Night cycle plus”
, you then
need to select a “Spin”
or “Drain”
pro-
gramme to finish the cycle and empty the water.
Selecting options
You must select the different options after select-
ing the programme and before pressing the “Start/
Pause” pushbutton (see “Programme table”).
Press the desired button(s) ; the corresponding
symbols appear on the display. If pressed again,
1) Depending on model.
4
electrolux
