9.8
Cancelling a programme
1.
Press the button
for some sec-
onds to cancel the programme and to
deactivate the appliance.
2.
Press the same button again to acti-
vate the appliance. Now, you can set
a new washing programme.
The appliance does not drain the
water.
9.9
Opening the lid
While a programme or the delay start op-
erates, the appliance lid is locked and the
display shows the indicator
.
CAUTION!
If the temperature and level of the
water in the drum are too high,
you cannot open the lid.
Open the appliance lid when the delay
start operates:
1.
Press
to pause the appliance.
2.
Wait until the lid lock indicator
goes off.
3.
You can open the lid.
4.
Close the lid and press the
again.
The delay start continues to operate.
Open the appliance lid when the
programme operates:
1.
Press the
button for some sec-
onds to deactivate the appliance.
2.
Wait for some minutes and then open
carefully the appliance lid.
3.
Close the lid and set the programme
again.
9.10
At the end of the
programme
• The appliance stops automatically.
• The acoustic signal operates (if it is acti-
vated).
• In the display a
comes on.
• The indicator of the
goes off.
• The lid lock indicator
goes off.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Close the water tap.
•
Press the button
for some sec-
onds to deactivate the appliance.
• Keep the lid ajar, to prevent the mildew
and odours.
The washing programme is
completed, but there is water in the
drum:
– The drum turns regularly to prevent the
creases in the laundry.
– The lid lock indicator
is on. The lid
stays locked.
– You must drain the water to open the
lid.
To drain the water:
1.
If necessary, decrease the spin
speed. If you set
, the appli-
ance only drains.
2.
Press
. The appliance drains
the water and spins.
3.
When the programme is completed
and the lid lock indicator
goes
off, you can open the lid.
4.
Press the button
for some
seconds to deactivate the appli-
ance.
The appliance drains and spins
automatically after approximately
18 hours (except for Wool pro-
gramme).
9.11
AUTO Stand-by option
The AUTO Stand-by option automatically
deactivates the appliance to decrease the
energy consumption when:
• You do not use the appliance for 5 mi-
nutes before you press
.
Press the button
to activate the ap-
pliance again.
• After 5 minutes from the end of the
washing programme
Press the button
to activate the ap-
pliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a new
cycle.
ENGLISH
13
