Electrolux EWS 86110W, Руководство пользователя

Страница: 17 / 48

5. Unscrew the hose from the machine.
Keep a rug nearby because some water
may flow.
6. Clean the filter in the valve with a stiff
brush or with the piece of cloth.
7. Screw the hose back to the machine
and make sure the connection is tight.
8. Turn on the water tap.
Emergency emptying out
If the water is not discharged, proceed as
follows to empty out the machine:
1. pull out the plug from the power socket;
2. close the water tap;
3. if necessary, wait until the water has
cooled down;
4. open the pump door;
5. place a bowl on the floor. Remove the
emergency emptying cap from the filter.
The water should drain by gravity into
the bowl. When the bowl is full, refit the
cap into the filter. Empty the bowl. Re-
peat the procedure until water stops
flowing out;
6. clean the pump if necessary as previ-
ously described;
7. screw the pump again and close the
door.
Frost precautions
If the machine is installed in a place where
the temperature could drop below 0°C,
proceed as follows:
1. Pull out the plug from the power socket.
2. Turn off the water tap.
3. Unscrew the inlet hose.
4. Place the end of the inlet hose in a bowl
placed on the floor, open the emergen-
cy emptying cup of the filter and let wa-
ter drain out.
5. Refit the emergency emptying cap into
the filter and screw the water inlet hose
back.
6. When you intend to start the machine
up again, make sure that the room tem-
perature is above 0°C.
Important! Every time you drain the water
for emergency you must pour 2 litres of
water into the main wash compartment of
the detergent drawer and then run the drain
programme. This will activate the
ECO
Valve device avoiding that part of the
detergent remains unused at next washing.
WHAT TO DO IF…
Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engi-
neer. Before contacting your local Service
Centre, please carry out the checks listed
below.
During machine operation it is possible that
the
red pilot light of button 5 blinks to indi-
cate that the machine is not working.
It is possible to recognize the machine fault
by the number of button
5 light flashes. If
the number of flashes is different from the
ones indicated below, this is related to a
fault that you
cannot solve. In this case,
contact your local Service Centre.
Press simultaneously the buttons
4 and 5
for a few seconds. The red button 5 light
will flash for a short time as described (the
green flash is not to be considered) :
•
4 flashes = «The washing machine
does not start»
, follow the correspond-
ing suggestions in «Possible cause/Solu-
tions» box and restart the programme.
electrolux 17