Electrolux EWF 14591 W, Руководство пользователя

Страница: 10 / 28

Fabric Soil Level
30°C X X X X
Cold X X X X
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out .
Before you make any change, you must
PAUSE the appliance by pressing the button
8 (if you wish to change the Time Manager
option, you must cancel the running pro-
gramme and make your selection again).
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
and then to the new pro-
gramme position. Start the new programme
by pressing the button
8 again. The washing
water in the tub will be not emptied out.
Interrupting a programme
Press the button 8 to interrupt a programme
which is running, the corresponding green
pilot light starts blinking.
Press the button again to
restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you need
to open it, set first the machine to PAUSE by
pressing the button
8 .
After a few minutes the pilot light 9 goes out
and it is possible to open the door.
If this pilot light remains lit, this means that
the machine is already heating or that the
water level is too high. In any case, do not try
to force the door!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to
O . After a few mi-
nutes the door can be opened (pay atten-
tion to the water level and tempera-
ture!)
.
After closing the door, it is necessary to se-
lect the programme and options again and to
press button
8 .
At the end of the programme
The machine stops automatically. Three
blinking
0.00 appear on the display and the
pilot light of button 8 goes off. Some acoustic
signals sound.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked to indicate that the wa-
ter must be emptied out before opening the
door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
O .
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8 .
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
gramme selector dial to
O to switch the ma-
chine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleasant
smells.
Stand By : If your laundry is not removed
within 10 minutes after the programme is fin-
ished, the back light of the display switches
off and the energy saving system will be en-
abled. Only the pilot light of the button
8 is
blinking to indicate that the appliance has to
be switched off. By pressing any button the
appliance will come out from the energy sav-
ing status and you can set another pro-
gramme or switch the appliance off.
Helpful hints and tips
Sorting out the laundry
Follow the wash code symbols on each gar-
ment label and the manufacturer’s washing
instructions. Sort the laundry as follows:
whites, coloureds, synthetics, delicates,
woollens.
10 electrolux