Electrolux EWF 12821, Руководство пользователя

Страница: 33 / 40

installation
electrolux
31
Connect the water inlet hose to a tap
with 3/4” BSP thread.
Use the hose supplied with the washing
machine. DO NOT USE OLD HOSES.
The other end of the inlet hose which
connects to the machine can be turned
in any direction.
Simply loosen the fitting, rotate the hose
and retighten the fitting, making sure
there are no water leaks.
The inlet hose must not be lengthened. If
it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink using
the plastic hose guide supplied with
the machine.
Water inlet
Water drainage
In this case, make
sure the end
cannot come
unhooked when
the machine is
emptying.
Never place cardboard, wood or similar
materials under the machine to
compensate for any unevenness in the
floor.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets,
rugs etc. Check that the machine does
not touch the wall or cupboard units.
Carefully level by
screwing the
adjustable feet in
or out.
This could be done by tying it to the tap
with a piece of string or attaching it to
the wall.
In a sink drain pipe branch . This
branch must be above the trap so that
the bend is at least 60 cm above the
ground.
Directly into a drain pipe at a height
of not less than 60 cm and not more
than 90 cm.
The end of the drain hose must always
be ventilated, i.e. the inside diameter of
the drain pipe must be larger than the
outside diameter of the drain hose.
The drain hose must not be kinked. Run
it along the floor; only the part near the
drainage point must be raised.