Electrolux EWF 1098, Инструкция пользователя

Страница: 22 / 24

22
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Force Centre, please carry out the
checks listed below.
IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect
use or installation, a charge will be made even if the appliance is under guarantee.
During machine operation it is possible that one of the following alarm codes appears on the display and the
“End” light starts to flash:
-
E10 : problem with the water supply
- E20 : problem with water draining
- E40 : door open
Once the problem has been eliminated, press the START/ADD CLOTHES button to restart the programme. If
after all checks, the problem persists, contact your local Service Force Centre.
Something not working?
The machine does not
start • The door has not been closed. (E40)
• The plug is not properly inserted in the power socket.
• There is no supply at the socket.
• The main fuse or the fuse in the plug has blown.
• The Start / Pause button has not been pressed.
• The DELAY START has been selected.
The machine does not
fill
• The water tap is closed. (E10 )
• The filter in the inlet hose is blocked. (E10 )
• The inlet hose may be squashed or kinked. (E10 )
• The door has not been closed. (E40)
The machine fills then
empties immediately • The end of the drain hose is too low.
• The end of the drain hose is submerged in water.
• There is no vent in the end of th
e
drain hose.
The machine does not
empty and/or does not
spin
• The drain hose may be squashed or kinked. (E20)
• The option has been selected.
• The drain pump may be blocked. (E20)
• The drain hose extension, if fitted, is not correct. Follow the
instructions for connecting to the waste.
• The drainage system pipes are blocked.
• The wash load is unbalanced: redistribute the clothes inside the
drum to allow the machine to spin.
There is water on the
floor • Too much detergent or unsuitable detergent has been used
(creates too much foam).
• Check whether there are any leaks from the inlet hose fittings. It is
not always easy to see this as the water runs down the hose; check
to see if it is damp.
• The drain hose may be damaged or not securely positioned.
• The detergent dispenser drawer or recess is clogged.
• The drainage system pipes are blocked.
•
The cap on the emergency emptying hose has not been replaced
after cleaning the pump.
Possible causes
Problem